Herunterladen Inhalt Inhalt Diese Seite drucken

Recommended Fuel; Operation; Starting The Engine; Switching Off The Engine - Scheppach 5806204986 Original Bedienungsanleitung

Inverter stromerzeuger
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Recommended fuel

Unleaded regular gasoline with a research octane number of 91 or higher is required for this engine.
Use only fresh and clean fuel.
m Water or impurities in the petrol damage the fuel system.
Tank volume: 4,1 litre
m Refuel in a well-ventilated area with the stopped engine. If the engine has been running,
allow it to cool first. Never refuel the engine inside a building where gasoline fumes may
reach flames or sparks.
Petrol is highly flammable and explosiv. You can get burns or other serious injuries when
handling fuel.
• Switch off the engine and keep it away from heat, sparks and flames.
• Refuelling only outdoors.
• Immediately clean up spilled petrol.

9. Operation

9.1 Starting the engine

• Vent the tank lid to „ON" position (Fig. 3)
• Set the on/off switch to the "RUN" position (Fig. 4).
In "warm" condition
• Starting the engine with the recoil starter ; therefor tighten handle sharply. Attach the recoil starter
gently and slowly by hand in the original position. If the engine hasn't started yet, tighten the handle
further. (Fig. 2 Pos. 4)
In "cold" condition
• Set the on/off switch to the "CHOKE" position (Fig. 4).
• Starting the motor with the recoil starter; therefor tighten handle sharply. Attach the recoil starter
gently and slowly by hand in the original position. If the engine hasn't started yet, tighten the handle
further. (Fig. 5)
Note:
When the engine is started the first time, several attempts are necessary for starting up to transport
the fuel from the tank to the engine.
• After starting the engine (after approx. 15-30 s), move the on/off switch (3) from the "CHOKE" po-
sition to the "RUN" position. (Fig. 4)

9.2 Switching off the engine

• Let the generator run briefly without load before you turn it off, so that the aggregate can "recooling"
• Set the on/off switch to the "OFF" position (Fig. 4).
9.3 Oil warning light (13)
Display is active at low oil level and deactivated when sufficient oil level.
34 | GB
www.scheppach.com

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Igt2500

Inhaltsverzeichnis