Installation; Cleaning Before Use; Before Plugging In You Must - Veripart VPMKK50 Gebrauchsanleitung

3. INSTALLATION

Before installing the refrigerator, carefully review the safety information
(section 1).
3.1 LOCATION
Ventilation
When selecting a position for your fridge you should make sure the floor is
flat and firm, and the room is well ventilated. Avoid locating your fridge near
a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight in
out-buildings or sun lounges. If you are placing your fridge in an out-building
such as a garage or annex ensure that the fridge is placed above the damp
course, otherwise condensation will occur on the fridge cabinet. When
working, the refrigerator gives off heat to its surroundings. Therefore, at least
30mm of free space should be left on the top, more than 100mm on both
sides, and more than 50mm at the back of the refrigerator.

Cleaning before use

Wipe the inside of the fridge with a weak solution of bicarbonate of soda
then rinse with warm water using a damp sponge or cloth. Wash the baskets
and shelves in warm soapy water and dry completely before replacing in the
fridge. The external parts of the fridge
can be cleaned with a non-abrasive detergent diluted in warm water.

Before plugging in YOU MUST:

Check that you have a socket which is compatible with the plug supplied with
the fridge. Check BEFORE switching on!
Do not switch on until four hours after moving the fridge.
The coolant fluid needs time to settle. If the appliance is switched off at any
time, wait 30 minutes before switching back on to allow the coolant fluid
to settle.
39