Installation - Veripart VPMKK50 Bedienungsanleitung

INSTALLATION

LOCATION
Location
When selecting a position for your fridge you should
make sure the floor is flat and firm, and the room is
well ventilated. Avoid locating your fridge near a heat
source, e.g. cooker, boiler or radiator. Also avoid
direct sunlight in out-buildings or sun lounges. If you
are placing your fridge in an out-building such as a
garage or annex ensure that the fridge is placed above
the damp course, otherwise condensation will occur
on the fridge cabinet. When working, the refrigerator
gives off heat to its surroundings. Therefore, at least
30mm of free space should be left on the top, more
than 100mm on both sides, and more than 50mm at
the back of the refrigerator.
Levelling the fridge
If the fridge is not level, the door and magnetic seal
alignment will be affected and may cause your fridge
to work incorrectly. Once the fridge is placed in its
final location, adjust the leveling feet at the front by
turning them.
Cleaning before use
Wipe the inside of the fridge with a weak solution
of bicarbonate of soda then rinse with warm water
using a damp sponge or cloth. Wash the baskets and
shelves in warm soapy water and dry completely
before replacing in the fridge. The external parts of the fridge
can be cleaned with a non-abrasive detergent diluted in warm water.
34