Nilfisk SC530 53 BD GO Schnellstartanleitung Seite 10

SC530 QUICK START GUIDE
NOTE
The machine requires two 12 V batteries,
connected according to the diagram (Figure. 3).
The machine can be supplied in one of the following modes:
A) Batteries (WET or GEL/ AGM) already installed and charged
1. Check that the batteries are connected to the machine with the connector (38).
2. Insert the ignition key (54) and turn it to "I". If the green warning light (53) turns on, the batteries are fully
charged.If the yellow (52) or red warning light (51) turns on, the batteries must be charged (see the procedure in
Maintenance chapter).
B) Without batteries
1. Buy appropriate batteries (see the Technical Data paragraph).
2. For battery choice and installation, apply to qualified battery Retailers.
3. Set the machine and the battery charger according to the type of batteries (WET or GEL/ AGM), as shown in the
next paragraph.
BRUSH/PAD-HOLDER INSTALLATION AND UNINSTALLATION
NOTE
Install either the brush (A, Figure 4) or pad-holder (B and C, Figure 4) according to the type of
floor to be cleaned.
CAUTION!
Before installation or uninstallation of brush or pad-holder, make sure all the switches on
machineare in off position and lifting up the squeegeefrom the floor. The operator must be
equipped with suitablepersonnel protection devices such as gloves to reduce the risk of accidents.
Proceedas following:
1. Insert the ignition key (54) and turn it to "O".
2. Lift the deck by pressing the pedal (10).
3. If equipped, turn the speed adjuster (56) to idle by turning
it counter-clockwise.
4. Place the brushes (A, Figure. 4) or the pad-holder (B)
under the deck (21).
5. Lower the deck on the brushes/pad-holders by pressing the
pedal (10).
6. Turn the ignition key (54) to "I".
7. Press theBrush/pad-holder and vacuum system switch (60).
8. Press one of the safe switch (50) to engage the brush/pad-
holder,then release it. If necessary, repeat the procedure
until the brushes/pad-holders are engaged.
WARNING!
(Only for machine with traction): Turn the speed adjuster (56) counter-clockwise to drive the
machine at the minimum speed.
Slightly press the safe switch(50), otherwise the machine starts to move.
To engage the safe switch (50) which turns on the brush/pad-holder motor.
9. To remove the brush/pad-holder lift the deck by pressing the pedal (10), then press the switch (58),the brush/pad-
holder will be remove.
7
ENGLISH
-
+
12V
12V
-
+
Figure 3
A
C
Figure 4
B