Removing/Inserting The Battery; Recharging The Battery; Used Batteries; Operating - FLORABEST FAH 18 C4 Originalbetriebsanleitung

• Charge the battery before the first time
of use. Do not briefly charge the bat-
tery several time in a row.
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM spare
battery available from our Customer
Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information.
• The warranty excludes all defects
caused by improper handling.
Removing/inserting the
battery
1. To remove the battery (9) from the
appliance, press the release but-
ton (10) on the battery and pull
out the battery.
2. To insert the battery (9), place it
on the guide track (14) and push
it back into the appliance. It will
audibly snap in.

Recharging the battery

Recharge the battery when the last
charge state indicator LED (
changes from green to red.
1. Remove the battery (9) from the
appliance, as necessary.
2. Insert the battery (9) in the charg-
ing compartment of the battery
charger (12). It will audibly snap
in.
3. Plug the battery charger (12) into
a mains outlet.
An LED charge status indicator
( 11) of the battery (9) flashes
4. When the battery is fully re-
5. Press the release button (

Used batteries

• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Waste Disposal and
Environmental Protection").

Operating

Wear suitable clothing and
work gloves when working
11)
with the equipment.
Ensure that the equipment is
functional before each use.
The On/Off switch and the
safety switch must not be
held closed. They must switch
off the motor when on is re-
leased. Should a switch be
damaged, stop working with
the equipment. Ensure that the
mains voltage value matches
the label on the equipment.
green while charging.
For each section of the battery
that is already charged, a green
LED lights up. When all three
LEDs of the charge status indica-
tor light up in green, the battery is
fully charged.
charged unplug the battery charg-
er (12) from the mains.
the battery (9) and pull the battery
out of the battery charger (12).
GB IE
10) on
13