Inhaltsverzeichnis
Werbung
60
put down after it has come to a complete standstill.
PLUNGE CUTTING
Fig.E
•
Plunge cutting may only be used on soft materials
such as wood, aerated concrete, gypsum plaster
boards, etc.
•
However, this requires a certain practise and is only
possible with short saw blades.
•
Place the saw onto the workpiece and switch it on.
•
Ensure that the bottom edge of the footplate rests
on the workpiece surface as shown.
•
Slowly saw into the workpiece at an angle, moving
the saw to a vertical position and continue to saw
along the cutting line.
•
Switch the saw off and lift off the workpiece when the
work is complete.
FLUSH SAWING
•
Elastic bi-metal saw blades allow you to saw projec-
ting objects (e,g, water pipes, iron bars, etc,) flush
against the wall.
•
Apply the saw blade directly to the wall and bend
slightly so that the footplate rests against the wall.
•
Switch the machine on and saw off the workpiece
keeping constant lateral pressure against the wall.
There are no user servicable parts in this unit. Any
repairs or servicing should be carried out by qualified
service en-gineers.
TROUBLESHOOTING
In case the machine does not work well, we give you
some possible causes and solutions.
1. The electromotor gets hot
•
The cool ventilation slots in the motor are stopped
up with dirt.
Clean the cool ventilation slots.
•
The motor is defect.
Have your machine repaired or checked by your local
Ferm dealer.
2. The connected machine does not work
•
Interruption in the mains connection.
Check mains connection for fracture.
Have your machine repaired/checked by your local
Ferm dealer.
Repairing of electric appliances may be carried out
only by experts.
4. MAINTENANCE
Make sure that the machine is not live when car-
rying out maintenance work on the motor.
The Ferm machines have been designed to operate over
a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon pro-
Ferm
Ferm
per machine care and regular cleaning.
Cleaning
Keep the ventilation slots of the machine clean to pre-
vent overheating of the engine.
Regularly clean the machine housing with a soft cloth,
preferably after each use. Keep the ventilation slots free
from dust and dirt.
If the dirt does not come off use a soft cloth moistened
with soapy water. Never use solvents such as petrol,
alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
Lubrication
The machine requires no additional lubrication.
Faults
Should a fault occur, e.g. after wear of a part, please con-
tact your local Ferm dealer.
In the back of this manual you find an exploded view
showing the parts that can be ordered.
ENVIRONMENT
In order to prevent the machine from damage during
transport, it is delivered in a sturdy packaging. Most of
the packaging materials can be recycled. Take these
materials to the appropriate recycling locations.
Take your unwanted machines to your local Ferm-
dealer. Here they will be disposed of in an environmen-
tally safe way.
GUARANTEE
The guarantee conditions can be found on the separately
enclosed guarantee card.
ı
( UK )
CE
DECLARATION OF CONFORMITY
We declare under our sole responsibility that this
product is in conformity with the following
standards or standardized documents
EN50144-1, EN50144-2-11,
EN55014-1, EN55014-2,
EN61000-3-2, EN61000-3-3
in accordance with the regulations.
98/37/EEC,
73/23/EEC,
89/336/EEC
from 01-09-2004
ZWOLLE NL
W. Kamphof
Quality department
5
Werbung
Inhaltsverzeichnis
