Adjusting The Closing Pressure Of The Door - Austroflamm Clou Compact 2.0 Betriebsanleitung

10 | Settings

10.4 Adjusting the closing pressure of the door

Fig. 43: Removing lower front cladding
2
1
Fig. 44: Adjusting the closing pressure of the
door
90
EN
Only the left side cladding needs to be removed for this
step.
1) To remove the cover and the side cladding, Proceed
as described in the section Removing the side clad-
ding [}on page 76].
2) Open door.
3) Undo the screws at the bottom and remove cladding.
ü At the bottom of the door there is a bolt which can used
to adjust the door closing pressure.
4) Use an open-end wrench to secure the bolt at the
lower end (1).
5) Using a screwdriver, the closing pressure can be ad-
justed with the screw (2).
6) Remount front cladding and side cladding and attach
cover.
ð Closing pressure is adjusted
Operating manual Clou Compact 2.0