Settings; Adjusting The Door - Austroflamm Backfach Installationsanleitung

7 | Settings

7 Settings
Have the maintenance carried out by an Austroflamm dealer.
7.1

Adjusting the door

Fig. 16: Adjusting the door
Fig. 17: Setting the door below
2
Fig. 18: Adjusting the door
40
2
1
1
EN
1) Loosen the screws and move the bolt sideways to ad-
just the door tilt angle.
2) The seal pressure can also be adjusted.
3) Then tighten the screws again.
1) Loosen the screw (1) and use the plate to correctly set
the door tilt angle.
2) Once the desired setting has been carried out, tighten
the screw (1) again.
 The screw (1) must be set in the centre so that the door
seals properly and engages properly at the notch (2) on
the handle.
1) The adjustment can be made at the back of the screw
(1) using the screws and the plate.
2) Check that the screw (1) correctly engages the notch
(2) and that the door is tightly closed. Should this not
be the case, repeat the previous step and correctly
adjust the screw (1).
Backfach