Panasonic ES-LV6U Betriebsanleitung Seite 17

2
Press for more than
2 seconds to activate the
sonic vibration cleaning
mode�
• Splashing of foam is suppressed.
• The battery capacity lamps blink
in order.
• After about 20 seconds, it will be automatically
turned off, or you can turn it off by pressing the
power switch.
3
Remove the outer foil
section [A] and clean
with running water�
• See page 18 for removing the
outer foil section.
• Splashing is reduced by rinsing the shaver in sonic
vibration cleaning mode.
• After rinsing with water, shake the shaver up and
down for a few times to remove excess moisture and
then wipe off any drops of water with a dry cloth.
4
Dry the outer foil section,
the shaver, and the
trimmer [A] completely.
• Allow the shaver to dry in the
shade, avoid direct sunlight.
5
Lubricate the shaver�
It will keep the movement of the
blades smooth and maintain a
comfort shave.
ES-LV6U_EU.indb 17
1. Apply one drop of oil to each of the system outer
foils.
2. Raise the trimmer and apply a drop of oil.
3. Switch the shaver on, and run it for approximately
five seconds.
4. Switch off the shaver, and wipe off any excess oil
from the system outer foil with a soft cloth.
Notes
• Do not use any kitchen or bathroom detergents other
than hand soap.
Doing so may cause malfunction.
• Be careful not to hit the main body on the sink or any
other object while draining the water. Failure to do so
may cause malfunction.
• Do not wipe with thinners, benzine, alcohol etc.
Doing so may cause malfunction, cracking or
discoloration of the parts.
Wipe with diluted soapy water.
Cleaning the system outer foil
Remove the outer foil section.
(See page 18.)
Wash the system outer foil in the areas
indicated by the circles every time you
use the shaver. Otherwise, abnormal
sound may be generated.
17
2021/12/07 21:15:27