Sainlogic FT0835 Benutzerhandbuch Seite 31

2. Replace the wind, rain and thermo-hygrometer transmitter
batteries once every 1-2 years
12. Troubleshooting Guide.
Problem
Wireless remote not
reporting in to
console.
There are dashes
(--.-) on the display
console.
If any of the sensor communication is lost, dashes
(--.-) will be displayed on the screen. To reacquire
the signal, press and hold the CHANNEL/+ button
for 3 seconds, and the remote search icon
be constantly displayed. Once the signal is
reacquired, the remote search icon
and the current values will be displayed.
The maximum line of sight communication range is
100 m and 30 m under most conditions. Move the
sensor assembly closer to the display console.
If the sensor assembly is too close (less than
1.5m), move the sensor assembly away from the
display console.
Make sure the remote sensors are not transmitting
through solid metal (acts as an RF shield), or earth
barrier (down a hill).
Move the display console around electrical noise
generating devices, such as computers, TVs and
other wireless transmitters or receivers.
Move the remote sensor to a higher location. Move
the remote sensor to a closer location.
30
Solution
will
will turn off,