Sainlogic FT0835 Benutzerhandbuch Seite 21

11. Rainfall Units of Measure (default: mm). Touch the SET key
again to change the Rainfall units of measure. Touch [+] key or [-]
key to toggle the rainfall units between mm and inch.
12. Barometric Pressure Display Units(default: hPa). Press the
SETkey again to change the pressure units of measure. Press the
[+] key or [-] key to toggle the pressure units between mmHg, inHg
or hPa.
13. Pressure Threshold Setting (default level 2). Press the SET key
again adjust the Pressure threshold setting. Press [+] key or [-] key
to adjust the pressure threshold setting up or down.
14. Weather Forecast Icon Setting (default: partly cloudy). Press
the SET key again to set the weather forecast icon initial conditions
(based on the current weather conditions). Press the [+] key or [-]
key to toggle weather icons between sunny, partly cloudy, cloudy,
or rainy.
15. Location division.(default: Northern Hemisphere) Press the SET
key again to change the location division. Press the [+] key or [-]
key to toggle the Northern Hemisphere (NOR)or Southern
Hemisphere(SOU).(refer to 5.0 Final Installation of Integrated
outdoor transmitter)
7.3 Sensor Search Mode
If outdoor sensor loses communication, dashes (--.-) will be displayed.
To reacquire the lost signal, press and hold the CH/+ button for 3
seconds to enter the sensor search mode.
7.4 Reset Min/Max record
Note:The minimum and maximum value of all channels will be
cleared in the reset mode.
In normal mode, Press (do not hold) the MIN/MAX/-key, and the MAX
icon will be displayed. Press the SET key to view rainfall (1h, 24h, week
or month) , pressure (ABS or REL) max value ,outdoor temperature
(temperature, dew point or feels like).
Next, press and hold the MIN/MAX/- key for three seconds(and the
CLR character is flashing in time area) to clear the rainfall, wind speed,
wind gust, pressure, temperature and humidity maximum values. The
maximum values will now display the current values.
20