Weather Forecasting - Sainlogic FT0835 Benutzerhandbuch

21. Indoor temperature high alarm
22. Indoor temperature low alarm
23. Indoor humidity high alarm
24. Indoor humidity low alarm
Note: To prevent repetitive alarming of humidity, there is a 4%
tolerance band. For example, if you set the high alarm to 60% and
silence the alarm, the alarm icon will continue to flash until the humidity
falls below 56%, at which point, the alarm will reset and must increase
above 60% to activate again.
8.4 Alarm and Command Key Beeper ON/OFF Mode
The beeper can be silenced for both alarms and key strokes.
In normal mode, press and hold the ALARM key for three seconds to
toggle the beeper on or off (depending on the current setting).
The BZON (beeper on) or BZOFF (beeper off) icon will appear in the
time area for three seconds. Press and hold the ALARM key again for
three seconds to toggle the BZON or BZOFF command.
9. Other Console Features
The following section describes additional features and display icons.

9.1 Weather Forecasting

Note: The weather forecast or pressure tendency is based on the
rate of change of barometric pressure. In general, when the pressure
increases, the weather improves (sunny to partly cloudy) and when the
pressure decreases, the weather degrades (cloudy to rain).
The weather forecast is an estimation or generalization of weather
changes in the next 24 to 48 hours, and varies from location to location.
The tendency is simply a tool for projecting weather conditions and is
never to be relied upon as an accurate method to predict the weather.
24