If the floor nozzle (turbo
brush) (14) is no longer working
properly:
1. Remove the floor nozzle (turbo
brush) (14) from the tube ex-
tension (11) or from the suction
tube (8).
(14)
2. Push the slider (54) on the
underside of the floor noz-
zle (turbo brush) (14) to the
'Open' position (towards the
symbol).
3. Remove the locking latch (55).
Care and maintenance
4. Remove the brush (20).
(54)
5. Remove any lint and hairs
from the brush (20).
6. Reinsert the brush (20) and
the locking latch (55) and
move the slider (54) to the
"Closed" position (towards the
symbol).
(55)
Page EN-33
(20)