Bosch GCM 10 J Professional Originalbetriebsanleitung Seite 27

OBJ_BUCH-1156-002.book Page 27 Friday, December 12, 2014 10:16 AM
Floor Strips/Mouldings
The following table contains instructions for sawing floor strips/mouldings.
Settings
Bevel angle
Floor strip/moulding
Inner corner Horizontal mitre angle
Positioning of
workpiece
The finished work-
piece is located ...
Outer corner Horizontal mitre angle
Positioning of
workpiece
The finished work-
piece is located ...
Ceiling Strips/Mouldings (According to US Standard)
When the ceiling strips/mouldings are to be sawn lying flat on the saw table, the standard mitre angles of
52°
31.6° (horizontal) and 33.9° (vertical) must be set.
The following table contains instructions for sawing ceiling strips/mouldings.
38°
Settings
Bevel angle
Ceiling strip/moulding
Inner corner Horizontal mitre angle
Positioning of
workpiece
The finished work-
piece is located ...
Outer corner Horizontal mitre angle
Positioning of
workpiece
The finished work-
piece is located ...
Checking and Adjusting the Basic Adjustment
 Before any work on the machine itself, pull the mains
plug.
To ensure precise cuts, the basic adjustment of the machine
must be checked and adjusted as necessary after intensive use.
Bosch Power Tools
Placed
against the
fence
0°
Left side Right side
45° left 45° right
Bottom edge on Bottom edge on
saw table saw table
... to the left of the ... to the right of the
cut cut
45° right 45° left
Bottom edge on Bottom edge on
saw table saw table
... to the right of the ... to the left of the
cut cut
Placed
against the
fence
52°
0°
Left side Right side
45° right 45° left
Bottom edge Bottom edge
against the fence against the fence
... to the right of the ... to the left of the
cut cut
45° left 45° right
Bottom edge Bottom edge
against the fence against the fence
... to the right of the ... to the left of the
cut cut
A certain level of experience and appropriate specialty tools
are required for this.
A Bosch after-sales service station will handle this mainte-
nance task quickly and reliably.
English | 27
Lying flat on
the saw table
45°
Left side Right side
0° 0°
Upper edge against Bottom edge
the fence against the fence
... to the left of the ... to the left of the
cut cut
0° 0°
Bottom edge Upper edge against
against the fence the fence
... to the right of the ... to the right of the
cut cut
Lying flat on
the saw table
33,9°
Left side Right side
31.6° right 31.6° left
Upper edge against Bottom edge
the fence against the fence
... to the left of the ... to the left of the
cut cut
31.6° left 31.6° right
Bottom edge Upper edge against
against the fence the fence
... to the right of the ... to the right of the
cut cut
1 609 92A 0XH | (12.12.14)