Safety Instructions; Safety Hints - Wolf Garten Rq 250 Gebrauchsanweisung

GB

Safety instructions

Please read the instructions for use carefully. Note the tips and explanations given. The instructions will help you to aquaint
yourself with the use of the trimmer. Please retain this information for subsequent reference.
The observance of the instructions specified is the basic requirement for the regular use of the trimmer.
1. General
x This trimmer is ideal for trimming lawn edges and small lawn areas in private gardens. The trimmer should not be used in
public gardens, parks, sports grounds, streets etc. and in farming and forestry.
x Because of possible accidents the trimmer must not be used for:
- trimming of bushes and hedges
- cutting of flowers
- cutting garden by-products for composting
x For safety reasons, the trimmer is not for use by persons below 16 years of age and persons who are not familiar with its
handling.
x Make sure that no persons (in particular children) or pets are in the vicinity of the working area. You are responsible for
damages.
x Never operate the unit in the presence of individuals (particularly children) or animals.
x Only operate the unit in daylight hours or if adequate artificial lighting is available.
x Use trimmer when the weather is dry and do not leave it outside when it rains.
x Use a residual current device (RCD) rated for a residual current not greater than 30 mA.
x Never install metal cutting elements.
2. Before operation
x Before starting the trimmer, clear all string, wire etc. away from the area to be cut. Whilst cutting look out for foreign ob-
jects.
x All cable must be inspected regularly for signs of damage or ageing. Use only in perfect condition!
x Tool must not be used when the safety device or the covering is damaged.
x For safety reasons only original WOLF spare-parts or parts appointed by the manufacturer shall be used. Please note the
installation instructions!
x Before adjusting or cleaning the tool and before checking for a caught or damaged connecting cable, switch off the tool
and disconnect the mains plug.
x Before starting the unit, and after any impacts, examine the unit for signs of wear or damage. Have any detected damage
repaired immediately.
3. Cable:
x The cable connectors must be made of rubber or must be rubber-lined and must conform to national legislation as appli-
cable.
x The cables' plugs must be made of rubber or must be rubber-coated and correspond to DIN/VDE 0620.
x Use a residual current device (RCD) rated for a residual current not greater than 30 mA.
x Do not allow the cable to strike the ground or edges of walls.
x Repairs should be done by experts.
4. Working
x Always keep hands and feet well clear of the cutting mechanism, particularly when starting the unit.
x Avoid injury from each of the components which serve to cut the line length. After pulling out a new length of line, always
hold the unit in its normal operating position before starting it.
x When starting the trimmer hold its base parallel to the lawn area in order to avoid accidents.
x Keep your hands away from the moving cord.
x Wear eye protection!
x Always wear appropriate working clothes and sound footwear when using the trimmer.
x Before carrying the trimmer to the next lawn area to be cut, switch it off.
x Be careful when you go backwards. You may stumble!
x Keep the cable away from the cutting tool.
x Should the powercord be damaged during use, immediately disconnect it from the mains. Do not touch the cable until it
has been disconnected from the mains.
x Never leave the trimmer without supervision. Store it in a safe place.
x The switches installed shall not be removed or bridged over, e. g. by binding the switch to the handle.
x Do not allow the cord spool to strike the ground or edges of working area. If the cord spool receives a hard knock, this
will cause a strong vibration on the handle. If this occurs, the trimmer should be checked by a qualified service centre.
5. After operation
x After using the unit, disconnect the power cord from the wall outlet and inspect the unit for damage.
x When switching off the trimmer: Attention: the cutting tool does not stop immediately!
x Always wait for the cutting tool to stop.
x Before examining or cleaning the tool or before removing the safety device or the cord spool, switch off and disconnect
the trimmer from the mains. Only use original WOLF cord spools and note the installation instructions!
x The cutting knife should not be cleaned under running water or under high-pressure.
x Faults shall only be repaired by appointed service centres or by the manufacturer.
x Make sure all air holes are free of dirt.
x Do not store the unit within reach of children.
20