EN
16
Installation
4.9 Electrical connection
Observe all safety and warning information (see the
"Safety" chapter).
Observe all national and regional laws and
regulations as well as the supplementary
regulations of the local utility companies.
The power connection may only be established by
certified specialists. The specialist also assumes
responsibility for the proper installation and
commissioning.
Connections via plug-in contacts (Schuko plugs)
are not permitted.
Position of the terminal box in the appliance:
Switch off the main switch/automatic circuit breaker
before connecting the cooktop.
Secure the main switch/automatic circuit breaker
against being switched back on without permission.
Make sure the power to the appliance is
disconnected.
The hob has been fitted with a temperature-resistant
connection cable in the factory.
If the mains cable is damaged, it will need to be
replaced with a new one. In order to avoid any risks,
this must be carried out by certified specialist.