Monosem MICROSEM Anleitung Seite 9

DANGER Z ONES
The area sho n in the diagram indicates the danger one of the machine.
SEED P A TER W T DA GER O E D AGRAM
Failure to respect the danger one can result in serious in ury or death.
eep people a ay from the danger one.
Only move the machine hen no one is in the danger one.
Operate the machine's various equipment only if no one is in the danger one.
When or ing on the machine even for short periods of time or for close visual inspections secure the tractor and the machine.
Do not par in the one of action of the furro ers.
OVERHEAD LINES
Observe the maximum possible height of the three-point lin age.
When folding and unfolding ensure su cient distance from po er lines.
ever get on or off the machine under po er lines to avoid the ris of electric shoc due to voltage discharges.
When or ing ma e sure you eep a su cient distance from po er lines.
FERTILIZ ERS AND TREATED SEEDS
Only use fertilisers and seeds that meet the requirements.
Avoid all contact direct or by inhalation
Do not to use of damp fertili er or seed to avoid bloc age in the box or hopper.
t is al ays recommended to mix talcum po der ith the seeds to reduce friction bet een seeds.
MAINTENANCE AND REPAIR INSTRUCTIONS
Ma e sure to s itch off the engine remove the ignition ey and
operation on the machine.
The PTO must be disengaged the engine s itched off and the ignition ey removed before carrying out any maintenance servicing or repair or on the machine.
Scre s and nuts must be tightened regularly. After the first hours of use (4 hours) all scre s must be retightened. Repeat the operation every 80 hours.
Before carrying out any maintenance or on a raised machine first support it.
Do not or under the machine ithout securing it.
Do not use the lifting eye to lift the machine hen it is loaded.
Wear gloves and use only the correct tools hen replacing a or ing part.
t is prohibited to thro a ay oil grease or filters in consideration of the environment.
The po er source must be disconnected before any or is carried out on the electrical circuit.
Parts sub ect to ear and tear should be chec ed regularly and replaced if orn or damaged.
The use of MO OSEM spare parts is mandatory as these correspond to the characteristics defined by the manufacturer.
The alternator and battery cables must be disconnected before any electrical elding or is carried out on the tractor or coupled machine.
Only qualified personnel may carry out repairs involving parts under voltage or pressure.
ENVIRONMENTAL PROTECTION
Consumables such as hydraulic oil lubricants etc. can harm the environment and people's health.
Ma e sure that used grease and substances such as oils fats or product residues after use are not spilled on the ground and are not disposed of in the se er system.
Absorb spilled consumables ith absorbent material or sand collect them in a lea -proof container and dispose them in accordance ith legal requirements.
Observe the instructions of the manufacturer of the consumables.
ntervene hen the eather conditions are favourable for the maximum e ciency of the phytosanitary product used limiting the impact of this product on the
environment as much as possible.
SPARE PARTS
The use of MO OSEM spare parts is mandatory as these correspond to the characteristics defined by the manufacturer.
The installation or use of parts that are not original MO OSEM parts may in some cases endanger the safety of people and the machine.
The company Ribouleau MO OSEM cannot be held liable for damage due to the use of non-original parts and accessories.
f in doubt about the assembly of equipment and spare parts contact your dealer or the MO OSEM customer service department.
MODIFICATIONS TO THE MACHINE
Construction modifications that are not authorised by MO OSEM may affect the correct operation and safety of the machine.
The user or o ner is responsible for any modifications to the machine that are not approved by MO OSEM.
MO OSEM cannot be held liable for damage to persons or damage to property resulting from unauthorised modifications
ith the products. Observe the instructions of the manufacturer of the supplies.
ait for all moving parts to come to a complete stop before leaving the tractor or performing any
9