Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Instructions for use
Robot vacuum cleaner
Power on/off
Press and hold the button
, to turn the robot on.
After startup, press and hold the
Note: When charging at the dust collector, the robot vacuum cleaner is
automatically switched on and cannot enter standby mode during the whole
charging process.
Clean/Pause
When switched on, short press the button
reachable area.
Press any button on the robot to stop cleaning.
If the battery is too low, cleaning will not start. Please charge the device first
and then restart cleaning.
If the battery charge is not sufficient during the cleaning process, the robot
vacuum cleaner automatically returns to the dust collector for recharging. As
soon as the battery reaches 80%, the robot will continue cleaning from the
previous position.
Note: It is recommended that the robot vacuum cleaner starts cleaning from
the suction station.
Dust collector
Start/Stop button
Short press: Start cleaning / Stop cleaning
Press for 3 seconds: Start spot cleaning
Pair dust collector and robot (paired in default factory settings)
1.
On the dust collector press the buttons
2.
On the robot vacuum cleaner press the button
3.
Place the Robot at the dust collector to charge. A voice prompt will confirm that pairing is/was successful.
, to shut down the system.
, to start cleaning the entire
and
for 5 seconds: The dust collector enters pairing mode. The three status LED's on the top flash green.
for 5 seconds: The robot enters pairing mode. The two status LED's on the top flash green.
Charging
Automatic charging: The robot vacuum Ccleaner automatically returns to the
dust collector to recharge, when cleaning is complete or when the battery
charge is insufficient.
Manual charging: Press the button
station and start charging. After pausing/stopping the robot, you can also
manually place it to the dust collector for charging.
Note: Please make sure that the charging contacts have good contact and
are clean.
Standby mode
If no cleaning cycle is started for more than 20 minutes, the robot vacuum
cleaner automatically enters standby mode.
Note: The Robot Vacuum Cleaner does not enter sleep mode while charging.
Note: If the robot vacuum cleaner has been paused or has stopped by itself
and it has insufficient battery, it will automatically shut down.
Home button
Short press: Return to the dust collector and start charging.
Press and hold for 3 seconds: Return to the dust collector, charge and then
continue cleaning at the previous position.
8
, to send the robot back to the charging
Werbung
Inhaltsverzeichnis
