Hayward AquaVac 250Li Benutzerhandbuch Seite 25

Debris escapes from the robot
Debris leaks outside at the
filter cover
Float sinks
Robot operation lasts shorter
than advertised
Robot cannot be charged /
recharged
Suction mouth's flap ( at cleaner bottom)
is damaged
Debris clogged at suction mouth and
prevents the flap to close.
Filter cover net is damaged
Float is broken and water leaks in
Battery is not fully charged
Battery is damaged
Charging base is not completely
connected with the external adaptor
and robot.
External adaptor is out of order
SAVE THESE INSTRUCTIONS
- Verify the smoothening-ring and bottom plate are installed
correctly (refer to below diagrams)
Inspect the smoothening-ring for potential damages and wear
and tear. Replace with a new one if necessary
Suction mouth's flap works like a door to prevent the debris from
escaping from the debris compartment.
Contact dealer for replacement parts and instruction.
Remove clogged debris from the suction mouth.
Replace with a new filter cover. Contact your dealer for
replacement parts.
Replace with a new float. Contact your dealer for replacement
parts.
Charge the robot for at least 6 hrs.
Contact dealer for battery replacement.
WARNING!
DO NOT replace the battery by
yourself. This could result in severe or fatal injuries and the
warranty will be voided as a result.
Make sure that the charging base is connected with external
adaptor and robot properly and completely.
Refer to instruction manual.
Contact dealer for replacement.
WARNING!
Using the wrong external adaptor
will result in damaging the robot / battery and voiding the
warranty as a result.
24