Hayward AquaVac 250Li Benutzerhandbuch Seite 20

Power indicator lights:
As the robot moves around the pool and collects debris, battery levels will gradually drop and
the indicator lights will follow suit.
NOTE:
- Refrain from making any physical contact with both water sensors.
4. To retrieve the robot from the pool, attach the hook to a telescopic pole (not provided) and
use it to retrieve the float, if you are unable to retrieve with your hands.
As the robot reaches the water surface, locate the end with the red triangle (as shown in the
image below) and grab onto the robot via the grip (Note: holding the other end of the robot will
lead to escape of debris through the drainage outlet) to lift the cleaner to drain the water out of
the robot.
5. Slide the power switch OFF. Rinse the robot with fresh water after every use. DO NOT use
any detergent.
NOTE: To ensure the most efficient cleaning, when your pool is quite dirty, it is recommended to
empty the debris compartment after the first 30min of operation, or whenever the robot's
movement has slowed down noticeably. Then return the robot (with an emptied debris
compartment) to the pool, and let it run through the remaining of its cycle.
4 lights ON Up to 120 minutes left
Only 10 minutes of usage remains
Last light blinks
once the last light starts blinking.
19