How To Use - Panasonic ER-CTB1 Betriebsanleitung

How to use

1
Mount the head to the main body until it clicks.
2
Mount the brush to the head.
▪ Apply a small amount of toothpaste.
3
Place the brush in your mouth.
▪ To avoid splashing of toothpaste, put the head in your
mouth before turning the power on.
4
Turn on the power.
▪ When first using this appliance, some people may
experience a tickling or tingling sensation caused by the
sonic vibrations. The sensation should subside after you
use the brush several more times.
5
Turn off the main body when you have finished brushing.
▪ Turn off the main body before removing it from your mouth
to prevent saliva from splashing.
Note
• The use time after a full charge is as follows.
ER‑CBL1: 110 minutes
ER‑CBN1: 70 minutes
(Use time may vary depending on ambient temperature and
use conditions.)
Quick charge (ER-CBL1 only)
Even though the battery runs out, you can use for 5 minutes
after 3‑minute charge.
(This will differ depending on usage.)
6
Removing and mounting
the head (Fig. 2)
• Make sure that the main body is turned off.
Remove the head while pushing the head release button (a).
▪ Stand the head when it is removed.
Mount the head to the main body until it clicks.
Removing and mounting
the brush
Rotate the head and align the marks and pull to remove
the brush. (Fig. 3-1)
▪ Pulling the brush while it is fastened may damage the head or
the main body.
▪ When toothpaste gets hard and makes it difficult to remove the
head, put it in water or warm water for a while and then remove.
Align the mark on the brush with the mark on the head and
rotate it in the direction of the arrow to mount the brush.
(Fig. 3-2)
▪ Inserting the brush without aligning the mark on the brush
with the mark on the head may damage the brush or brush
shaft (b).
Note
• The brush should be replaced with a new one every 3 months
or so due to hygiene reasons, even if its shape is unchanged.
Even within 3 months, please exchange the head if the
bristles are frayed.