Troubleshooting
a
10
Troubleshooting
Fault
Tension too low
Tensioned blind not running
smoothly
Powered blinds:
Blind stops in wrong position
Different blinds running at dif-
ferent speeds
Powered blind does not work ➤ Prolonged or repeated use can activate the built-in
20
Solution
➤ See chapter "Installing the cord plugs (only for
manual blinds)" on page 14 .
➤ Check restraint positions and recess dimensions.
➤ Refer to manual of your control device.
➤ Refer to manual of your control device.
thermal cut-out. Leave the motor to cool for 20 min
and try again.
➤ Check the power supply to the blind.
➤ Check if wiring for voltage to the motor is correct.
➤ If power supply is checked and the motor is still
faulty, contact Dometic.
Skysol Track Small
EN