Troubleshooting - Dometic ROLLERBLIND POWERED Montage- Und Bedienungsanleitung

Rollerblind Powered
Spot cleaning
➤ Spot-clean with a soft white cloth, moistened with warm water. Add a mild deter-
gent if needed (non-abrasive and with no additives).
➤ Blot gently to avoid creasing or damaging the fabric. Always leave the blind
deployed to dry thoroughly.
Cleaning windows
➤ Always ensure the blinds are fully stowed before cleaning windows. This will
prevent spoiling the blind fabric by splatter or sprays of water or detergent.
10

Troubleshooting

Fault
Guide wire tension too low
Guide wire too short
Guide wire broken
Motor not working
Guide wire or side track blind not running
smoothly
Side track not vertical
Fabric rolls off sides of ends of roller
Blind stops in wrong position
EN
Solution
➤ See chapter "Fitting the guide wire ver-
sions" on page 10.
➤ Order replacement guide wire, see
spares leaflet at dometic.com.
➤ Order replacement guide wire, see
spares leaflet at dometic.com.
➤ Check if wiring for voltage to the motor is
correct.
➤ If power supply is checked and the motor
is still faulty contact your distributor.
➤ If using the AP Remote control refer to the
AP Remote control manual.
➤ Check restraint positions and recess
dimensions.
➤ Check if the side tracks are fitted perpen-
dicular to the roller and parallel to each
other.
➤ Check if the guide wires or side tracks are
perpendicular to the roller and that the
roller is horizontal.
➤ Refer to manual of your control device
(e.g. AP Remote control).
Troubleshooting
13