First Installation - Foppapedretti ECE R44-04 Bedienungsanleitung

Fig 19: The carrycot is placed on the middle seat and on a side seat and is fixed with
the belts of these seats. The child's head must be level with the middle seat. This
configuration allows you to leave one seat free for a passenger.
CONFIGURATION NOT ALLOWED FOR INSTALLATION
Fig. 20: For greater safety of the child in the event of a side impact, when the
carrycot is placed on the side and middle seat, the child's head must not be on the
side seat near the door.
Fig. 21: The carrycot cannot be placed on one side of the rear passenger seat,
towards the door, and attached with the belt of the outer seat on the opposite side.
Fig. 22: The carrycot cannot be attached if the belt of the middle seat is located
internally to the carrycot.

FIRST INSTALLATION

To secure the carrycot to the rear car seat it must be positioned in the centre and
fastened using the belts of the two side
seats (Fig. 23). If the middle seat of the rear car seat is also fitted with a 3-point car
seatbelt, the carrycot can also be fitted at the side, so that it occupies the seat at
the side and the middle seat and is fastened with the seatbelts of these two seats
(Fig. 24).
1. Pull out and fasten the two car seatbelts to the respective seat buckles (Fig. 25).
2. Recline the backrest of the carrycot fully to the horizontal position, the only
position of the backrest authorised for the use of the carrycot in the car (see
carrycot instruction manual).
3. Make sure that the side safety padding has been fitted at the head of the carrycot.
4. Make sure that the lap belt has been fitted correctly.
WARNING!
• NEVER use the carrycot in the car with the backrest raised!
• NEVER use the carrycot in the car without the side safety padding.
• NEVER use the carrycot in cars that are not fitted with a lap belt. Baby must
always be fastened with the lap belt even on short journeys.
• If these instructions are not followed, the product CANNOT guarantee adequate
protection with serious risks for baby's safety in the event of an accident.
• Position the carrycot on the seat in a lengthwise position (Fig. 26), making sure
that it is fitted close to the seat.
• Carry out these procedures to fit the buckles properly on both sides of the carrycot:
• take hold of the car seatbelt and make a loop (Fig. 27).
• Grip the buckle of the carrycot and turn the red bar of the buckle downwards
(Fig. 28).
• Insert the loop created with the car seatbelt in the buckle (Fig. 29) and turn the
red bar to the initial position, so that it is inserted inside the loop itself (Fig. 30).
• Pull the car seatbelt towards the retracting device, pushing the carrycot against
the seat (Fig. 31).
20