Foppapedretti ECE R44-04 Bedienungsanleitung Seite 19

To facilitate the assembly of the 3-point seat belt, lift up the backrest (fig. 4).
Insert the metal loop, located at the end of the chest belt, through the chest slot on
the backrest (the mattress slot and rigid backrest support slot) (fig. 5) and through
the respective loop on the bottom of the carrycot (fig. 6), sliding the metal loop
completely through to the outside of the carrycot.
To facilitate assembly, adjust the support foot to a vertical position (fig. 7).
Place the metal loop in its housing, on the bottom of the carrycot, inserting it under
the locking tabs (fig. 8). Repeat these steps also for the second chest belt.
Insert the end, with the metal loop, of the leg separator strap through the slot in the
mattress and the respective slot on the bottom of the carrycot (fig. 9), sliding the
metal loop completely through to the outside of the carrycot.
Place the metal loop in its housing, on the bottom of the carrycot, inserting it under
the locking tabs (fig. 10).
Adjust the support foot into a horizontal position (fig. 11).
Adjust the headrest into a horizontal position, completely lowered (fig. 12).
Check that the 3-point seat belt is correctly assembled; by pulling the belt firmly
from the inside of the carrycot, the metal loops must stay locked in their housing
(fig. 13).
WARNING! Check that the 3-point seat belt is not twisted.
Safety padding
Insert the safety padding inside the carrycot, at the head of the carrycot (fig.14).
Assembly of buckles for attaching the car seat belt
To fasten the two buckles to pins "A" located at the ends of the carrycot (Fig. 15),
insert each buckle in its respective pin, pushing it (Fig. 15) and pull the buckle
downwards until a click is heard (Fig. 16).
Make sure it has been fastened properly.
WARNING! NEVER fit the buckles back to front (Fig. 17).
SECURING THE CARRYCOT IN THE CAR:
CONFIGURATION ALLOWED FOR INSTALLATION
The headrest must be adjusted to the horizontal position only, completely lowered.
Fig.18: The carrycot is placed in the centre of the rear passenger seat and secured
with the belts of the outer seat.
19