Start-Up - HomeMatic IP HmIP-SLO Montage- Und Bedienungsanleitung

6

Start-up

Please read this entire section before starting to
use the device.
You can connect the device either to the Access
Point or to the Homematic Central Control Unit
CCU2/CCU3. For detailed information about
teach-in or configuration via a control unit,
please refer to the Homematic IP User Guide,
available for download in the download area of
www.eQ-3.com.
First set up your Homematic IP Access Point via
the Homematic IP app to enable operation of
other Homematic IP devices within your system.
For further information, please refer to the oper-
ating manual of the Access Point.
To integrate the light sensor into your system and enable
it to communicate with other Homematic IP devices, you
must teach-in the device to your Homematic IP Access
Point first.
To teach-in the light sensor, please proceed as follows:
• Open the Homematic IP app on your smartphone.
Select the menu item "Teach-in device".
•
Remove the cap (A) if required (see fig. 2).
•
• Remove the insulation strip from the battery
Start-up
31