Activation Of The Flexible Cooking Zones (Model In4-2Fzs Only) - Pkm IN4-S Bedienungsanleitung

Only one cooking zone is activated: if you do not set a power level within 5
seconds after activating this cooking zone, the induction hob switches off
automatically. You must start at step 1 again.
7. You can vary the power level at any time during cooking.
T
HE DISPLAY INDICATES THE SYMBOL
a) you have not placed the cookware on the correct zone
b) you use unsuitable cookware
c) you use unsuitable cookware
d) you use cookware which is too small or not centred on the cooking zone
properly.
While using unsuitable cookware, the cooking zone does not heat up. The
display goes off after 1 minute automatically even if you have not placed suitable
cookware on the cooking zone.

4.4.1 Activation of the flexible cooking zones (model IN4-2FZS only)

You can place the cookware anywhere within the borders (white) of the flexible
cooking zones shown in the figure below (left and right / see also fig. in chapter
3.2 V :
IEW MODEL
When you activate the bridge-function of two cooking zones (e.g., the bridge-
function of cooking zone 1 and cooking zone 2 = flexible left cooking zone / s.
fig. below), the cookware must have a minimum diameter of 210 mm for an
optimum cooking result.
The
FLEXIBLE COOKING FUNCTION
simultaneously (see also chapter 4.6 « B
POWER LEVEL ALTERNATELY
IN4-2FZS).
~
AND THE INDICATOR OF THE
:
OR
OR
OR
and the « B » -
OOST
» -
OOST FUNCTION
~
86
can be used
FUNCTION
.