Troubleshooting; Motor Unit; Pole Pruner; Hedge Trimmer - FLORABEST FBK 4 B2 Originalbetriebsanleitung

5.) Add 1 teaspoon of 2-stroke oil to the combustion chamber. Pull the
starter pull cord several times in order to wet all mechanical parts
with oil. Replace the spark plug.
NOTE
■ Store the appliance in a dry place and away from possible ignition
sources.
Start-up after storage
1.) Remove the spark plug (see section "Spark plug maintenance").
2.) Pull the starter pull cord quickly in order to remove any excess oil
from the combustion chamber.
3.) Clean the spark plug and observe the correct electrode gap on the
spark plug.
4.) Fill the fuel tank . See the section "Fuel and oil".
Transporting
■ If you are planning to transport the appliance, empty the fuel tank
as explained in the section "Storage".

Troubleshooting

Motor unit

Problem Possible cause
The engine does Incorrect start-up process.
not start.
The engine starts Incorrect adjustment of the
but does not run
choke lever
at full power.
Contaminated air filter.
The engine does Incorrect spark plug gap.
not run smoothly.
Soot deposits or Incorrect carburettor adjust-
wetness on the ment.
spark plug.

Pole pruner

Problem Possible cause
Motor is running, Hedge trimmer attachment
or pole pruner attachment
saw chain
is not connected properly
does not move.
to the motor unit.
No work pro-
Saw chain
gress.
heating or is sagging.

Hedge trimmer

Problem Possible cause
Motor is running, Hedge trimmer attachment
blades do not or pole pruner attachment
move. is not connected properly
to the motor unit.
FBK 4 B2
Remedy
Follow the instructions
regarding starting.
Set the choke lever
.
to " ".
Clean air filter.
Clean the spark plug
and adjust the spark
plug gap or replace
the spark plug.
Clean spark plug or
replace it with a new
spark plug.
Remedy
Check assembly.
Top up the oil or
dry/over-
regrind, replace or tight-
en the saw chain
Remedy
Check assembly.

Maintenance interval

Pole pruner
The figures given here are based on normal operating conditions. In the
event of more difficult conditions, such as strong dust generation and
longer daily working hours, the given intervals are to be reduced corres-
pondingly.
Appli- Action
ance part
Lubricat- check
ing the
chain
Saw check and
note sharp-
chain
ness
check
chain
tension
sharpen
Guide check
(wear,
rail
damage)
clean and
turn
deburr
replace
Sprocket check
replace
Hedge trimmer
The figures given here are based on normal operating conditions. In the
event of more difficult conditions, such as strong dust generation and longer
daily working hours, the given intervals are to be reduced correspondingly.
Appli- Action
ance part
Cutting visual inspection
blades
clean

Spare part orders

.
Ordering spare parts
The following information should be provided when ordering spare parts:
■ Type of appliance
■ Item number of the appliance
■ Device ID number
Current prices and information are available at
www.kompernass.com
NOTE
■ Replacement parts not listed (such as strimmer, strimmer cord) can be
ordered via our service hotline.
Before Weekly In the In the
starting event event
work of of dam-
faults age
X
X
X
X
X X
X
X
X
Before After
starting com-
work pletion
of work
X
X
As re-
quired
GB
X
X
X
As re-
quired
X
69