Additional Functions; Access Sub Functions; Range; Hold - VOLTCRAFT VC151 Bedienungsanleitung

12. Additional functions

Button press:
• Short press = <2 sec.
• Long press = >2 sec.
a) Access sub functions
Several measuring functions are assigned sub functions, and are marked in red around the
function dial. Short press the SEL button to cycle through each sub function.
b) Range
Pressing the RANGE button will switch the DMM from automatic "Auto" range to manual range.
This mode is only applicable with the following functions: V , V , Ω, µA , mA , and A .
Enter manual range: Short press the RANGE button.
•
- "Auto" will disappear from the display.
- Short press RANGE to toggle through ranges (indicated by decimal position).
• Exit manual range: Long press the RANGE button or rotate the function dial, "Auto" will
appear on the display.
c) Hold
The hold function keeps the indicated value on the display so you have more time to read or
record it.
If you test live wires, make sure this function is deactivated before the measurement
starts. Otherwise, the measurement will not be correct.
• Short press the HOLD button to activate/deactivate the hold.
• The symbol will appear to indicate that hold is active.
d) Automatic power off
Automatic power off is an energy saving feature. When activated, the power will turn off if there
is no activity is detected for approximately 15 mins. Press any button or adjust the function dial
to wake.
51