7.1. Adjusting the aerial
A wire aerial has already been connected to the device for radio reception. Fully un-
wind the aerial and arrange it for optimum reception.
7.2. Mains connection
Connect the mains adapter.
To do this, place the connection cable plug in the socket
DC IN 5V
earthed power socket which is accessible at all times.
8. Volume
Turn the control knob on the side of the device -/+ to set the volume. The cur-
rent volume is shown in the display.
9. Lighting
Pressing the LIGHT button switches the integrated lighting on the underside of
the device on or off.
This light is only designed to light up foodstuffs and not for room light-
ing.
10. Setting the time
The device is equipped with the Radio Data System that sets the time automatically.
The correct time is synchronised after the device has been connected to the power
supply. In this process ---- flashes on the display. The time will appear once the pro-
cess has been completed.
In some cases, the time cannot be set if the radio signal is too weak. In this case,
00:00 is shown on the display and the time must be set manually.
40
2A and the mains adapter into a properly installed 230V ~ 50 Hz