11.3. Stopping the alarm / activating the snooze
function
When the alarm sounds, you can:
The alarm sound is output for 5 minutes. Press the ALARM button to stop the
alarm or press the controller to activate the snooze function. After approx. 9
minutes, the alarm sounds again. This can be repeated up to three times.
If the alarm is sounded using the radio, you can switch it off by pressing
snooze function is not possible.
11.4. Timer
You can set a timer to start in up to 300 minutes.
Press the TIMER button.
Turn the controller to select the duration until the timer starts.
Press the TIMER button to confirm.
The alarm starts 30 seconds before the set period of time has expired with the vol-
ume increasing gradually.
Press the TIMER button to stop the alarm.
If the timer has been activated, you can check the remaining time until the alarm
will sound:
Press TIMER. The remaining time is shown.
If you wish to cancel the timer, proceed as follows:
Press the TIMER button.
Turn the controller to select the duration 000.
Press the TIMER button again and the
12. Radio
12.1. Switching the radio on/off
Press the
button to switch the radio on/off.
You can receive analogue FM radio signal with this device. The display shows FM as
well as the frequency and time alternately. Adjust the wire aerial for optimal FM re-
ception.
12.2. Setting/searching for stations
Press the TUN- or TUN+ button to set a station manually.
Press and hold the TUN- or TUN+ button to search for stations. The search stops
automatically at the next station found.
42
flashes on the display.
flashes on the display.
symbol goes out.
. The