Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
AVOID THE RISK OF FATAL
INJURY FROM ELECTRIC SHOCK
We assume no liability for property damage or
personal injury caused by improper handling or
failure to observe the safety notices!
Never use the lamp if any defects have been
identified. Check the light and the mains cable
with the plug for any damage before con-
15
necting it to the mains.
Never open any of the electrical equipment or
insert objects into these. Such interferences pose
a risk of fatal injury from electric shock.
Only touch the insulated part of the mains plug
when connecting or disconnecting it from the
mains supply!
To avoid hazards, if the flexible lead on this
light is damaged it must be replaced by the
manufacturer, their service representatives or
an equivalent professional!
Before use, verify that the available mains volt-
age matches the required operating voltage of
the lamp (220–240 V∼, 50 Hz).
Under no circumstances should you allow liquids
or steam to enter the socket on the back! This
can cause it to short circuit and pose a risk of
death or serious injury.
Only use IPX4 plugs in the socket.
When using the built-in socket, the IP protection
is reduced to IP44 if a corresponding IP44 model
plug is used.
Disconnect the product from the mains supply
whenever you want to use it in a different
location.
Never carry the product by the mains cable.
Only use the handle piece to adjust the lamp,
not to carry it.
Do not connect the product in series.
PREVENT FIRE AND
INJURY HAZARDS
CAUTION! RISK OF BURNS DUE TO
HOT SURFACES! To prevent burns, ensure
that the lamp has been switched off and has
cooled down before touching it. Illuminants
become very hot.
16 GB/IE
Do not cover the lamp with objects. Excessive
heat build-up can result in fire.
Never leave the lamp unattended during oper-
ation. Excessive heat build-up can result in fire.
The LED lamp is not dimmable.
Do not look directly into the light source (light
bulb, LED etc.). Do not look into the light source
(light bulb, LED, etc.) with an optical instrument
(e.g. magnifying glass).
A shattered protective covering must
always be replaced.
Installation
DANGER OF ELECTRIC
SHOCK! Only insert the mains plug into the mains
socket after it has been assembled. Otherwise there
is a risk of electric shock!
Note: You can use the light as a handheld or floor
spotlight or with the tripod
Assembling the spotlights
and handle piece on the
mounting bracket
First, unscrew the pre-installed fixing material
(screws
, clamping nuts
6
pertaining to them) from the mounting bracket
(see Fig. A, ensure that the washers are in the
correct order).
Screw both spotlights
and the washers to the mounting bracket
4
(see Fig. B, ensure that the washers are in the
correct order).
Screw the handle piece
and the washers to the mounting bracket
(see Fig. C, ensure that the washers are in the
correct order).
Loosen the screw
12
handle piece
and attach the mains cable
1
bracket
to the handle piece
13
Note: You can use the light in this form as a floor
spotlight.
if necessary.
9
and the washers
4
with the clamping nut
2
5
with the screws
1
6
5
on the reverse side of the
(see Fig. D).
1
5
Werbung
Inhaltsverzeichnis
