Herunterladen Inhalt Inhalt Diese Seite drucken

Fax: +90 232 210; Specifications - Stihl SEA 20.0 Gebrauchsanleitung

Vorschau ausblenden Andere Handbücher für SEA 20.0:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

18 Specifications

Fault
LEDs on the
hand vacuum
The hand
3 LEDs emit red
vacuum cuts
light.
out during ope‐
ration.
The suction
1 LED flashing
power of the
green.
hand vacuum
decreases.
Hand vacuum
runtime is too
short.
17.2
Troubleshooting the Charger
Fault
LED on Char‐
ger
Battery not being
One LED glows
charged.
red.
The LED fla‐
shes red.
The charger
The LED
does not run a
glows green for
self test.
about 1 second
and then red
for about
1 second.
18 Specifications
18.1
STIHL hand vacuum SEA 20.0
– Approved battery: STIHL AS
– Weight without battery: 1.1 kg
– Maximum air throughput: 1026 l/min
– Maximum vacuum: 80 mbar
sample inspection
– Length: 465 mm
– Width: 113 mm
– Height: 187 mm
– Inside diameter suction hose: 29 mm
0458-006-9621-B
Cause
The hand vacuum or
battery is damp.
The hand vacuum is
too warm.
There is an electrical
fault.
State of charge of the
battery is too low.
The container is full.
The battery is not fully
charged.
The battery service
life has been excee‐
ded.
Cause
The battery is too
warm or too cold.
No electrical contact
between charger and
battery.
There is a malfunction
in the charger.
There is a fault in the
battery.
Electrical contact to
charger was briefly
interrupted.
– Maximum container capacity: 0.75 l
Consult www.stihl.com/battery-life for the respec‐
tive running time.
18.2
– Battery Technology: Lithium-ion
– Voltage: 10.8 V
– Capacity in Ah: see rating label
– Energy content in Wh: see rating label
– Weight in kg: see rating label
Remedy
► Allow hand vacuum or battery to dry.
► Remove the battery.
► Wait for the hand vacuum to cool down.
► Remove battery and reinsert it.
► Switch on the hand vacuum.
► Charge the battery.
► Remove the battery.
► Empty the container.
► Clean the hand vacuum.
► Fully charge the battery.
► Replace battery.
Remedy
► Leave battery inserted in charger.
Charging starts automatically as soon as
the permitted temperature range is rea‐
ched.
► Remove the battery.
► Clean contacts on charger.
► Insert battery.
► Do not use the charger and contact your
STIHL dealer for assistance.
► Do not use the battery. Consult a STIHL
dealer.
► Disconnect the mains plug from the
power supply.
► Wait for 1 minute.
► Insert the mains plug in a wall outlet.
STIHL AS Battery
English
33

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Sa03

Inhaltsverzeichnis