Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3) A sensor switched to RF+ALARM will always give an alarm sound
on the sensor itself, unless the alarm unit is armed or disarmed.
4) When a sensor is triggered and the siren of the alarm unit sounds,
it needs to be switched off with on/off switch of the alarm unit. Af-
ter that the alarm unit can be switched on again. When the alarm
keeps on going after arming the system, check if every sensor is
installed properly.
Installation SEC-ALARM120
1. Insert, according the diagram inside the battery compartment,
(backside) the batteries for the alarm unit (3xAA).
2. Install the door/window sensor with the adhesive tape to doors
and windows. Note: maximum 1cm distance between magnetic
contact and sensor (see fi gure 2). Switch on the sensor to RF
or RF+ALARM. If switched to RF+ALARM, the sensor will send,
when triggered, a signal to the alarm unit and the siren of the
sensor itself will also sound. In this case the siren of the sensor
and the alarm unit will both sound.
3. Insert, according the diagram inside the battery compartment,
(backside) the batteries for PIR sensor (3xAAA). The PIR sensor
needs to warm up for 30~40 seconds for fi rst use. In this period
it can not detect motion. Install the PIR sensor at a height of
1~1.5m for best performance. Do not install the PIR sensor into
direct sunlight, facing towards windows, objects that move easily
and heat or cold source.
4. Remove the transparent front cover of the alarm unit to write
down the position of the sensors corresponding with the num-
bered LED. (e.g. sensor 1 = front door, 2= kitchen window, etc.).
5. Install the alarm unit to a location. The distance between the
alarm unit and the most far away sensor may not exceed 60m
(open area)*
8
Werbung
