Konig Electronic SEC-ALARM100 Anleitung Seite 10

4) When a sensor is triggered and the siren of the alarm unit sounds,
it needs to be switched off with on/off switch of the alarm unit. Af-
ter that the alarm unit can be switched on again. When the alarm
keeps on going after arming the system, check if every sensor is
installed properly.
Specifi cations:
Alarm unit (fi gure 1):
• Power: 4.5 VDC (3x battery AA, not included)
• Standby current: <1.5 mA
• Chime current: <90 mA
• Alarm current: <130 mA
• Alarm volume: 100 dB (0.5m)
• Chime volume: 90 dB (0.5m)
• Switch: alarm/chime/off
• LED indicator: 6
• Frequency: 433 MHz ±250 kHz
• Dimensions: 5.7(W) x 3.9(D) x 10.9(H)cm
• Delay time: 20 ~ 25 sec.
Door/window sensor (fi gure 2):
• Power: 4.5 VDC (3x battery LR44, included)
• Standby current: <10μA
• Transmission current: <6 mA
• Working distance: +/- 60 m (open area)*
• Alarm volume: 95 dB (0.5m)
• Switch: RF + alarm/RF/off
• Frequency: 433 MHz ±250 kHz
• Dimensions with magnet contact: 6(W) x 1(D) x 9.9(H)cm
PIR sensor (fi gure 3):
• Power: 4.5 VDC (3x battery AA, not included)
• Standby current: <100μA
• Transmission current: <5mA
• Working distance: +/- 60 m (open area)*
• Detecting range: 5~8 m
• Detecting angle: 100° (horizontal) / 80° (vertical)
10