Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Description remote control (SEC-ALARM100/110/120):
Figure 5
Off button
Installation SEC-ALARM100
1. Insert, according the diagram inside the battery compartment,
(backside) the batteries for the alarm unit (3x AA).
2. Install the door/window sensor with the adhesive tape to doors
and windows. Note: maximum 1 cm distance between magnetic
contact and sensor (see fi gure 2). Switch on the sensor to RF
or RF+ALARM. If switched to RF+ALARM, the sensor will send,
when triggered, a signal to the alarm unit and the siren of the
sensor itself will also sound. In this case the siren of the sensor
and the alarm unit will both sound.
3. Remove the transparent front cover of the alarm unit to write
down the position of the sensors corresponding with the num-
bered LED. (e.g. sensor 1 = front door, 2= kitchen window, etc.).
4. Install the alarm unit to a location. The distance between the
alarm unit and the most far away door/window sensor may not
exceed 60 m (open area)*
LED indicator
4
On button
Werbung
