Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7. Switch on the alarm unit to ALARM or CHIME function. If switched
to CHIME, the alarm unit will sound like a door bell when a door
or window is opened. Switched to ALARM generates a 100dB
loud siren. When the alarm unit is switched on, the alarm is not
armed (active) yet. Push the ON button on the remote control to
arm the alarm and OFF to disarm. The delay time for entering
and leaving the protected area is between 20~25 seconds.
8. It's recommended to test the alarm system for correct operation
with fi rst use and every 3 months.
Procedure:
a) Switch on the alarm unit to ALARM or CHIME (for testing
recommend).
b) Push the ON button on the remote control to arm the alarm.
c) Wait for 20~25 seconds (delay time).
d) For testing door/window sensor, open every door or window
one by one and check if the corresponding LED lights up and
the CHIME sounds.
e) For testing PIR sensor, move around the PIR sensor and
check if the corresponding LED lights up and the CHIME
sounds. Note: the LED indicator on the PIR sensor lights up
also.
f)
For testing vibrate sensor, hit carefully on the window and
check if the corresponding LED lights up and the CHIME
sounds.
g) Disarm the alarm if everything operates correct.
h) The alarm system is ready to use.
Note:
1) the alarm unit will give a conformation tone when armed or dis-
armed. The tone for CHIME is different as for ALARM.
2) If a sensor does not need to be switched on, it's possible to
switch off every sensor individually with the on/off switch. In this
case the sensor is no part of the alarm system anymore when
armed (except PIR sensor).
7
Werbung
