Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation SEC-ALARM110
1. Insert, according the diagram inside the battery compartment,
(backside) the batteries for the alarm unit (3xAA).
2. Install the door/window sensor with the adhesive tape to doors
and windows. Note: maximum 1cm distance between magnetic
contact and sensor (see fi gure 2). Switch on the sensor to RF
or RF+ALARM. If switched to RF+ALARM, the sensor will send,
when triggered, a signal to the alarm unit and the siren of the
sensor itself will also sound. In this case the siren of the sensor
and the alarm unit will both sound.
3. Install the vibration sensor with the adhesive tape to windows
(on the glass). Switch on the sensor to RF or RF+ALARM. If
switched to RF+ALARM, the sensor will send, when triggered, a
signal to the alarm unit and the siren of the sensor itself will also
sound. In this case the siren of the sensor and the alarm unit will
both sound. Note: the vibrate sensor is very sensitive. The slight-
est vibration will trigger the sensor. It's not recommend to install
the vibrate sensor on windows near to doors. Slamming doors
will trigger the sensor.
4. Insert, according the diagram inside the battery compartment,
(backside) the batteries for PIR sensor (3xAAA). The PIR sensor
needs to warm up for 30~40 seconds for fi rst use. In this period
it can not detect motion. Install the PIR sensor at a height of
1~1.5m for best performance. Do not install the PIR sensor into
direct sunlight, facing towards windows, objects that move easily
and heat or cold source.
5. Remove the transparent front cover of the alarm unit to write down
the position of the sensors corresponding with the numbered LED.
(e.g. sensor 1 = front door, 2 = kitchen window, etc.).
6. Install the alarm unit to a location. The distance between the
alarm unit and the most far away sensor may not exceed 60m
(open area)*
6
Werbung
