Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. Switch on the alarm unit to ALARM or CHIME function. If switched
to CHIME, the alarm unit will sound like a door bell when a door
or window is opened. Switched to ALARM generates a 100 dB
loud siren. When the alarm unit is switched on, the alarm is not
armed (active) yet. Push the ON button on the remote control to
arm the alarm and OFF to disarm. The delay time for entering
and leaving the protected area is between 20~25 seconds.
6. It's recommended to test the alarm system for correct operation
with fi rst use and every 3 months.
Procedure:
a) Switch the alarm unit on to ALARM or CHIME (for testing
recommended).
b) Push the ON button on the remote control to arm the alarm.
c) Wait for 20~25 seconds (delay time).
d) Open every door or window one by one and check if the cor-
responding LED lights up and the CHIME sounds.
e) Disarm the alarm if everything operates correct.
f)
The alarm system is ready to use.
Note:
1) the alarm unit will give a conformation tone when armed or dis-
armed. The tone for CHIME is different as for ALARM.
2) If a sensor does not need to be switched on, it's possible to
switch off every sensor individually with the on/off switch. In this
case the sensor is no part of the alarm system anymore when
armed.
3) A sensor switched to RF+ALARM will always give an alarm sound
on the sensor itself, unless the alarm unit is armed or disarmed.
4) When a sensor is triggered and the siren of the alarm unit sounds,
it needs to be switched off with on/off switch of the alarm unit. Af-
ter that the alarm unit can be switched on again. When the alarm
keeps on going after arming the system, check if every door or
window is closed properly.
5
Werbung
