Repeat Function; Programming Playback; Audio Input - TechniSat DIGITRADIO 650 Bedienungsanleitung

16.6 Repeat function

You can select whether a track, the entire folder/album (only for MP3-CDs) or all of
the tracks on the CD are to be repeated.
> Press the Repeat button
The selected mode appears on the display using an icon (Repeat Track,
Repeat Album, Repeat All, Shuffle).
> To switch the function off again, press the Repeat track button as often as
required until the icon no longer appears.
> Press the Shuffle button to play the tracks in a random sequence.

16.7 Programming playback

You can programme up to 20 tracks on a CD in any sequence.
> Stop any playback in progress by pressing the STOP button
> Press the FAV button on the remote control to access the programming
mode.
The display now shows [P01] for the first track to be programmed.
> Using the
the storing.
> Then [PO2] is displayed for the second track which you can also add as
described above.
> When programming is complete, press the Playback/Pause button
To delete programming, either press Stop
the Eject button.

17 Audio input

You can play sound on an external device via the DIGITRADIO 650 speaker.
> Connect the external device to the AUX-IN port (15, 3.5 mm stereo jack) on
the back of the DIGITRADIO 650.
Alternatively:
> Connect the external device using the LINE-IN connection (14, stereo RCA
cable R/L) on the back of the DIGITRADIO 650.
> Use the MODE button to select the AUX-IN or LINE-IN audio input, depending
on which port the external device has been connected to. [Aux-In] or [Line-
In] appears on the display.
The playback is controlled on the external device. Do not set the volume too
low to prevent interference.
74
/ buttons, select a track and press the OK button to accept
several times.
2x or open the CD tray using
.
to play.