Emptying The Catcher; Charging The Battery - Meec tools 018285 Bedienungsanleitung

EN
resulting from improper use. The full
responsibility for any such personal injury
and/or material damage rests on the user.
The product is not intended for commercial
or industrial use. Commercial, professional or
industrial use (or equivalent) will invalidate the
warranty.
HOW TO USE
Adjusting the harness
Adjust the length of the harness strap so that
the suction tube is just clear of the ground.
The wheels on the bottom of the suction tube
facilitate the manoeuvrability of the suction
tube on the ground.
Starting
NOTE:
Do not start the product until it is fully
assembled.
The product is switched off when the power
switch is in the 0 position. The power switch
has 5 speed modes, where 1 is the lowest and
5 is the highest air speed. Start the product
by moving the power switch to the required
air speed mode. Switch off the product by
moving the power switch to position 0. Do not
use a higher air speed or motor speed than
necessary.
Mode selection
FIG. 9
Suction
Put the lever in VAC mode. This can be done
when the product is switched off or on.
Blowing
1. Put the lever in BLO mode. This can be
48
done when the product is switched off
or on.
2. Aim the air flow forwards and walk slowly
to blow the leaves and garden waste
together, or to clear places difficult to
reach.
IMPORTANT:
Empty the catcher before using the blower
function. Otherwise, material already
collected can be blown out.

EMPTYING THE CATCHER

Empty the catcher in good time. The suction
power is considerably reduced when the
catcher starts to get full. Organic waste should
be composted.
1. Switch off the product and remove the
battery.
2. Open the zip on the catcher and shake out
the contents.
3. Close the zip on the catcher.

CHARGING THE BATTERY

IMPORTANT:
Only use the battery and charger
recommended by the manufacturer.
NOTE:
• Charge the battery immediately when
the product loses power. Do not allow
the battery to fully discharge. Over-
discharging reduces the life span of the
battery.
• The charger and battery get warm when
charging. This is perfectly normal.
Charge the battery as soon as possible when it
is discharged for best life span.
1. Plug the charger into a power point.
2. Put the battery in place in the charger.
The status light flashes green and the