Fitting The Handle; Intended Use - Meec tools 018285 Bedienungsanleitung

DESCRIPTION
1. Handle
2. Harness
3. Upper suction tube
4. Lower suction tube
5. Catcher
6. Battery holder
FIG. 1
ASSEMBLY
NOTE:
Switch off the product and remove the
battery before adjustment, replacing parts,
cleaning and/or maintenance.
FITTING THE SUCTION TUBE
1. Fit the upper and lower parts of the
suction tube together.
FIG. 2
2. Tighten the screw. Both parts of the
suction tube must be fitted together
before the tube is put on the motor unit.
FIG. 3
NOTE:
Never take apart both parts of the suction
tube when it is fitted on the motor unit.

FITTING THE HANDLE

Put the handle on the fasteners on the cover.
Lock the handle in place with a screw on each
side.
FIG. 4
FITTING THE CATCHER
1. Hook the hook on the suction tube.
FIG. 5
2. Put the back edge of the catcher over the
fastener on the cover so that it clicks in
place.
FIG. 6
FITTING THE HARNESS
Undo the screw, pull the strap through the
opening and tighten the screw.
FIG. 7
INSERTING THE BATTERY
Press the battery lock and put the battery in the
holder. Check that the lock engages when the
battery is in place. Follow the instructions in
the reverse order to remove the battery.
FIG. 8
NOTE:
Only use the product together with the
battery and charger specified above. The use
of other batteries and/or charger can result
in a fire risk and/or serious personal injury.
USE
Battery and charger sold
separately in Jula's department stores and at
www.jula.com

INTENDED USE

The product is only intended to be used for
leaves and garden debris such as grass,
small branches and twigs. All other use is
considered to be unsuitable. The product
must only be used for its intended purpose
and in accordance with these instructions.
All other use is considered to be unsuitable.
The manufacturer cannot accept liability for
personal injury and/or material damage
EN
47