Meec tools 018285 Bedienungsanleitung Seite 42

EN
• Check and tighten any loose unions.
• Do not allow processed material to collect
in the ejector. This can prevent proper
emptying and can result in material being
thrown out through the infeed opening.
• If the product gets blocked, switch it off
and pull out the plug before clearing the
blockage.
• Keep the motor free from debris and other
sediment – risk of fire and/or overheating.
• Do not transport the product when the
motor is running.
• Do not tilt the product when the motor is
running.
• Switch off the product, pull out the plug
and wait until all moving parts have
completely stopped in the following
situations.
– Before leaving the product
unattended.
– Before removing a blockage.
– Before checking, cleaning or doing
any other work on the product.
– After a collision with an object. Check
the product for damage.
– If the product starts vibrating
abnormally (check immediately).
• Switch off the product, pull out the plug
and wait until all moving parts have
completely stopped before touching
moving parts.
• Do not use the product if the power cord
or plug are damaged, or touch the cord
before it is unplugged – risk of electric
shock.
• The overload protection switches off the
product automatically if there is a short
circuit or other fault.
• Switch off the product immediately if
there is a problem or malfunction. Release
the power switch to switch off the product.
• Switch off the product immediately if the
power cord gets damaged or entangled.
42
Do not touch the power cord before it is
unplugged – risk of electric shock.
• Keep the power cord away from moving
parts – risk of electric shock.
• Check before use that the power point and
power cords are undamaged, and that there
are no signs of fatigue. Only use the product
in dry and clean areas with adequate lighting.
• A damaged cord or plug must be replaced
by an authorised service centre or
qualified person to ensure safe use.
• Do not use the power tool if it cannot be
switched on and off with the power
switch. Power tools that cannot be
controlled with the power switch are
dangerous and must be repaired.
• Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to jam
and are easier to control.
• Use the power tool, accessories and bits
etc., in accordance with these instructions,
taking into account the actual working
conditions and the work that is to be
done. It can be dangerous to use power
tools for purposes other than those for
which they are intended to be used.
SPECIAL SAFETY INSTRUCTIONS FOR
BATTERY-POWERED PRODUCTS
• Only charge the battery with the charger
recommended by the manufacturer.
Charging other batteries can result in a
risk of personal injury and/or fire.
• Only use batteries recommended by the
manufacturer. The use of other batteries
can result in a risk of personal injury and/
or fire.
• When the battery is not in use keep it
away from metal objects such as
paper-clips, coins, keys, nails, screws and
other small metal objects that can short
circuit the terminals. Short circuiting
discharges large amounts of energy that
can cause a fire and/or burn injuries.