Lionelo Levi Simple Bedienungsanleitung Seite 15

•
Make sure the belt is not loose. Keep the child safety seat with
your knee, close to the car seat. Tighten the safety belt towards
the retractor as much as you can. See: fig. 21
•
Unfasten child safety seat belts and then put the child in. Fasten
5-point safety belt, put two parts of the belts into the buckle (I)
until you can hear a distinctive „click". See: fig. 22
•
Choose a suitable headrest height (2.2), pull safety belts so that
they fit tight the child's arms. Make sure the belt protective cushion
touches the child's arms and is not twisted with belts. See: fig. 24
•
Set the suitable length of belts. To do so, pull the tension adjustment
strap (M). See: fig. 23
3.2 Group II, III (15-36 kg), the child secured with 3-point car seat belts.
• Before you initiate installation, remove 5-point safety belts. See: fig.
32 – step-by-step instructions above (sub-chapter 2.5, sub-point A).
•
Place the child safety seat on the car seat. Press it against the seat
with your knee to make sure it fits tight the backrest.
•
Put the child in the child safety seat, adjust the headrest height to
the child. To do so, pull the headrest height adjustment lever (N).
See: fig. 8
•
Take car seat belts out.
• Pull the shoulder belt through the headrest guide (O). See: fig. 33
•
Pull the hip belt through under the elbow rest, through the red
guide (E). See: fig. 34
•
Pull both belts through under the second elbow rest (E) of the
child safety seat and fasten the belt until you can hear a distinctive
„click". See: fig. 35
•
Make sure the belt is not too loose. Tighten the safety belt towards
the retractor. The belt must be sufficiently tight but must not constrict
child's movements or press against it. See: fig. 21
Note! Check safety belts. The safety belts must go through the shoulder
guide in the upper part of the backrest and hip guide in the lower part
of the product.
‑ 15 ‑ EN