Technical Data; Declaration Of Conformity; Noise/Vibration Information; Mounting And Operation - Bosch GST 160 BCE Professional Originalbetriebsanleitung

OBJ_BUCH-2000-003.book Page 12 Monday, March 10, 2014 12:47 PM
12 | English

Technical Data

The technical data of the machine are listed in the table on
page 183.
The values given are valid for a nominal voltage [U] of 230 V.
For different voltages and models for specific countries,
these values can vary.

Declaration of Conformity

We declare under our sole responsibility that the product
described under "Technical Data" is in conformity with the fol-
lowing standards or standardisation documents: EN 60745
according to the provisions of the directives 2009/125/EC
(Regulation 1194/2012), 2011/65/EU, 2004/108/EC,
2006/42/EC.
Technical file (2006/42/EC) at:
Robert Bosch GmbH, PT/ETM9,
D-70745 Leinfelden-Echterdingen
Henk Becker Helmut Heinzelmann
Executive Vice President Head of Product Certification
Engineering PT/ETM9
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 22.05.2013

Mounting and Operation

The following table indicates the action objectives for mounting and operation of the power tool. The instructions for each action
objective are shown aside. Depending on the type of application, various instruction combinations are required. Observe the
safety instructions.
Action
Inserting the Saw Blade
Ejecting the Saw Blade
Switching on the sawdust blower
device
Connecting the dust extraction
Adjusting the Cutting Angle
2 609 932 925 | (10.3.14)

Noise/Vibration Information

The measured values of the machine are listed in the table on
page 183.
Noise and vibrational values (vector sum of three directions)
determined according to EN 60745.
The vibration level given in this information sheet has been
measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with anoth-
er. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main ap-
plications of the tool. However if the tool is used for different
applications, with different accessories or insertion tools or is
poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working
period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep the hands warm, organisation of work pat-
terns.
Figure Please observe
1
2
3
4
5
Page
184
184
184
185 –186
186 –187
Bosch Power Tools