Greasing The Gas Tap; Replacing Parts; Instructions And Warning For Replacing Parts; Replacing The Top Burner Nozzle (Ø 80 - 4 Kw) - Angelo Po 1N1FAG - 1T1FAG Bedienshandbuch

To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Pull off the knob (A).
2)
Take out the screws (C) and take down the
3)
dashboard (B).
Undo the screws (D) and extract the cap (E).
4)
Pull off the cone (F).
5)
Clean the cone (F) as well as its seat.
6)
Coat the cone with grease (F), fi t it in its seat
7)
and turn it a few times.
Pull off the cone (F) to remove the excess
8)
grease.
Replace the cone (F) and the cap (E).
9)
Replace the control panel (B) and the knob
10)
(A) on completion of the operation.

INSTRUCTIONS AND WARNING FOR REPLACING PARTS

Important
Before carrying out any replacement procedure,
activate all the safety devices provided and deci-
de whether staff at work and those in the vicini-
ty should be informed. In particular, turn off the
gas supply tap and prevent access to all devices
which might cause unexpected health and safe-
ty hazards if turned on.
If work parts have to be replaced, use original
spare parts only.
REPLACING THE TOP BURNER NOZZLE (Ø 80 - 4 KW)
To carry out this operation, proceed as follows.
Turn off the gas supply
1)
tap.
Remove the grid (A).
2)
Extract the burner (B).
3)
Unscrew the nozzle (C)
4)
and replace it with the
one suitable for the type
of gas in use (see table at
back of manual).
Replace the burner and
5)
the grid.
3319970_inst_GB_rev.1

GREASING THE GAS TAP

REPLACING PARTS

A
- 15 -
A
C
B
The manufacturer declines all responsibly for
injury or damage to components due to the use
of non original parts, or extraordinary work on
the appliance which may modify the safety re-
quirements without the manufacturer's autho-
risation.
When ordering components, follow the instruc-
tions provided in the parts catalogue.
B
E
F
C
D
C
ENGLISH
GB
8