Cleaning And Maintenance - Klarstein Hot Spot Crystal Flow Bedienungsanleitung

EN
than before, appliance will consider the window is open and stop heating. At the same
time, the icon stops flashing and keep lighting up to remind user to close the window.
When the window is closed, touch to recover normal operation , flashes again.
Recovery of Factory Setting
Touch + and - at the same time twice quickly. The appliance will recover to initial factory
setting.

CLEANING AND MAINTENANCE

The filter will become very dirty after day after day usage. Please clean the filter after
around 150 hour usage.
Steps to remove and assemble filter
Use screw driver to unscrew 2 screws ST3X10 from filter, then remove the left and right
filters. Re-assemble the filter according to the reference line (see drawing below).Push
the filter to the end until it cannot move anymore.
Maintenance
1. Always disconnect the heater and let it cool down completely before carrying out
any maintenance.
2. Use a vacuum cleaner to remove dust on inlet and outlet surfaces.
3. Clean the outside of the unit with a damp cloth and then dry it with a dry cloth.
35