Klarstein Hot Spot Crystal Flow Bedienungsanleitung Seite 32

EN
32
1. PTC heating (1800W): Touch
light up, PTC heating is working at high power 1800W. Touch
low power 1 100W, only one icon low power 1 100W, only one icon
2. Panel Heating (200W): Touch
3. Full power heating (2000W): When panel heating works, touch
heating at high power 1800W. Then total power is 2000W.
Note: at this stage, touch
power (1800W- 1 100W- 0W)
WARNING
Risk of burns! The glass surface and air outlet bottom will become
very hot. Be careful and avoid touching it.
Temperature Setting
After power is set, touch + or - to set temperature among 5-40 °C
The display screen will change accordingly. Once temperature is set, the setting will be
dconfi rmed in 5s automatically.
When ambient temperature reaches the set temperature, appliance will stop heating.
When ambient temperature drops 1 °C lower than the setting, appliance will resume
heating to keep the ambient temperature at set level.
Note: Set temperature must be higher than ambient temperature. Or appliance will not
start heating.
Mode Setting of Week Timer - Auto Start
In standby mode, touch
UP, then touch to confi rm setting.
P1, P2, P3, P4, P5 modes are default program for quick setting
• P1: all day comfort mode
• P2: mode for general family
• P3: mode for working offi ce
• P4: mode for commercial plaza
• P5: mode for family on travel or trip
button to turn on the appliance. Both icons
lights up.
once to start panel heating.
will switch PTC heating from high power – low power – no
button to switch working mode among P1- P2-P3-P4-P5-
once to switch it
to switch PTC