Klarstein Hot Spot Crystal Flow Bedienungsanleitung Seite 31

Plug in supply of 220-240V~ 50Hz. Push the ON/OFF (0/I) button located at the left
side of the heater to switch it on. Buzzer will have a short "D" sound. Display and button
will light up for 10s.
Touch once to turn on heating. Button light will go out in 10s when no operation is
conducted. Touch any button could reactivate the button light.
Touch once again to turn off heating. The appliance stays in standby mode.
Note: Motor will continue working for extra 15s to drive away the residue heat inside
unit before turning off.
To switch the appliance off, push ON/OFF (0/I) button again and disconnect the plug.
Set local day and time
At the fi rst time usage, icon
time before further operation.
Long touch button for 3 seconds to activate timer setting, fi gure 1 of '1 2 3 4 5 6
7' will fl ash, touch '+' or '-' to select the day, the selected fi gure will fl ash accordingly.
Touch to confi rm the day setting. Then come to hour-setting, '88' fl ashes, touch +
or - to select the hour among 0-23, touch
minute-setting, '88' fl ashes, touch + or - to select the minute among 0- 59. Touch
confi rm minute setting.
Note: program will automatically return to initial display in 10s when no operation is
conducted during setting.
Power Setting
PTC heating high power
PTC heating low power
Panel Heating
Full power
will keep fl ashing to remind user to set local day and
to confi rm hour setting. Then come to
Power Icon Display
1800 W
1 100 W
200 W
1800 W +
200 W
= 2000 W
to
Function
Room heating
Room heating
Towel heating
Room heating
+ towel heating
EN
31