ratiotec rapidcount M 120 Bedienungsanleitung Seite 28

Infrared error 1
Infrared error 2
Infrared error 3
Colour error 1
Colour error 2
Colour error 3
MG error 1
MG error 2
MG error 3
UV error 1
UV error 1
UV error 1
Image error 1
Image error 2
Image error 3
Denomination
Version
Banknote twisted or
off-centred
Dog-eared
Torn banknote
Jam
[///////////////]
Should the error messages still show after trying these measures, please contact your
distributor.
Error with the IR test
Error with the colour recognition
Error with the Magnetic test
Error with the UV test
Error with the Image recognition
The denomination of banknote does not
match the reference denomination.
The version of banknote does not match the
reference denomination.
A banknote is twisted or off-centred when
fed.
The banknote is dog-eared.
The banknote is damaged and the machine
cannot recognise the denomination.
A banknote is jammed in the machine.
The machine has not recognised the
banknote
IR sensors must be eventually cleaned, contact your distri-
butor. Remove the last banknote ejected. Then continue the
counting procedure with the START key.
Colour sensors must be eventually cleaned, contact your
distributor. Remove the last banknote ejected. Then conti-
nue the counting procedure with the START key.
MG sensors must be eventually cleaned, contact your distri-
butor. Remove the last banknote ejected. Then continue the
counting procedure with the START key.
UV sensors must be eventually cleaned, contact your distri-
butor. Remove the last banknote ejected. Then continue the
counting procedure with the START key.
CIS sensors must be eventually cleaned, contact your distri-
butor. Remove the last banknote ejected. Then continue the
counting procedure with the START key.
Remove the last banknote ejected. Then continue the coun-
ting procedure with the START key.
Remove the last banknote ejected. Then continue the coun-
ting procedure with the START key.
Remove the last banknote ejected. Then continue the coun-
ting procedure with the START key.
Remove the last banknote ejected and check if it is in proper
condition. Then continue the counting procedure with the
START key.
Remove the last banknote ejected. Then continue the coun-
ting procedure with the START key.
Open the machine with the unblocking keys, remove the
banknote. Then continue the counting procedure with the
START key.
Remove the last banknote ejected. Then continue the coun-
ting procedure with the START key.